You may find that the Yanmar Panel B won’t allow you to connect your “idiot-light” circuit in parallel, as the EMU-1’s 50kohm input impedance may be enough to very slightly activate a sensitive engine buzzer. However, you could try the following fix...
Read More
To date, the only gauges we know of that are NOT compatible with the EMU-1 are VDO Viewline 12/24V gauges. We will continue to monitor and update this list accordingly...
Read More
The recommended wire to use between the gauge/sensor and the EMU-1 connectors will be a minimum of “24 AWG (0.5 mm diameter)”...
Read More
The current version of the Toolkit (that contains the EMU Configuration Tool) does not offer this as a feature...
Read More
Yes, from EMU-1 firmware v0.041 (and onwards) the Engine Operating hour log is stored in non-volatile memory and restored at the start of every session. Note that in EMU-1 firmware v0.022 (and below) the Engine Operating hour log...
Read More
The default NGT-1 baud rate from firmware version 2.600 is 230,400...
Read More
There was one error in issue 1.00 of the EMU-1 user manual. On page 12 the text should read...
Read More
This temperature range is dependent on what gauge is defined by EMU Configuration Tool for that input. An EMU-1 “Gauge” input set to measure “Temperature” is capable of measuring temperatures outside of the defined gauge range...
Read More
Yes, the EMU-1 is compatible with both single and dual station senders...
Read More
