What is needed to configure the EMU-1
The Actisense Toolkit configures the EMU-1 – please see the Toolkit Manual for further details of how to use this software.
To change the default settings in the EMU-1 to match your installation the Actisense NGT-1 Or an NGX-1 is required. It would be advantageous to leave the NGT/NGX-1 on-board as it is a great NMEA 2000 diagnostic tool when working with our freely available software NMEA Reader. As your NMEA 2000/SeaTalkNG network grows, being able to see what messages and devices are on your network will become vital to help you understand any issues.
The Actisense NGT/NGX-1 is a very versatile PC Interface that works with a wide range of Windows software. Please look at the software compatibility page for a list of the software that can be used.
NGT/NGX-1’s use a baud rate of 115200, which is ideal for use on an NMEA 2000 network with a peak bus load below 50%. NMEA Reader displays the current “NMEA 2000 Bus Load” to help the user understand if the peak bus load is above 50%, and if so allow the user to change the NGT/NGX-1 baud rate to 230400 baud rate.
EMU-1 Default Configuration
To help you decide if you need to change the settings in the EMU-1, please refer to the default configuration below.
|
EMU-1 input |
Setting |
|
G1 – Gauge 1 |
Temperature Sender, 287 – 22 Ohm, VDO (40 – 120 degC) Euro |
|
G2 – Gauge 2 |
Oil Pressure Sender, 10 – 180 Ohm, VDO (0 – 80 PSI / 0 – 5 Bar) Euro |
|
G3 – Gauge 3 |
Disabled without configuration |
|
G4 – Gauge 4 |
Disabled without configuration |
|
G5 – Gauge 5 |
Disabled without configuration |
|
G6 – Gauge 6 |
Disabled without configuration |
|
A1 – Alarm 1 |
Disabled without configuration |
|
A2 – Alarm 2 |
Disabled without configuration |
|
A3 – Alarm 3 |
Disabled without configuration |
|
A4 – Alarm 4 |
Disabled without configuration |
|
T1 – Tacho 1 |
Alternator, ‘W’ connection – 11.78 Pulses Per Revolution (PPR) |
|
T2 – Tacho 2 |
Disabled without configuration |
|
X1 – Aux 1 |
Not in use (not configurable). Reserved for future feature addition. |
|
X2 – Aux 2 |
Not in use (not configurable). Reserved for future feature addition. |
What these setting look like in Toolkit:
EMU-1 Default Settings
Further Reading
For more information on NMEA 2000 and how it works, please download our free guide to NMEA 2000 networking here: https://actisense.com/complete-guide-to-building-an-nmea-2000-network/